Additive Pipe Pressure (negative pressure) Water Supply Equipment

• Customization: Available
• Max.Head: 50-80m
• Max.Capacity: 200-300 L/min
• Model NO.: LZW(I)
• Pressure Medium: Water
• Type: Desktop
• Position of Pump Shaft: Vertical Edge
• Certification: CE, ISO, RoHS
• Series: Lzw(I)
• Transport Package: Wood Box
• Specification: CE
• Trademark: Liansheng or OEM
• Origin: Shanghai, China
• HS Code: 84101330
• Production Capacity: 2000

Product Description

Products Name: Additive Pipe Pressure (negative pressure) Water Supply Equipment

Working conditions:

1, environment temperature: 4 Centigrade ~40 Centigrade;

2, relative humidity: <90% (20 Centigrade), outdoor allow 95%, without dew;

3: <0.5g, vibration, vibration frequency 10Hz~150Hz, the maximum acceleration should not exceed 5m/s2;

4, tilt<5 °

5, the power supply frequency: 50 Hz ± 5%;

6, the power supply voltage: 380V ± 10%;

7, altitude: Not more than 1000m;

8, equipment operation site should be no conductive or explosive dust, non corrosive metal or gas insulation failure or steam.

9, pressure precision: <0.01Mpa

10. Pressure range: 0~2.0Mpa

11, flow range: 0~600m3/h

fault phenomenon	failure cause	elimination methods
	1.No power supply or one or two phase power supply is needed	Check all phases of power supply and restore power supply
	2.Poor contact of ac contactor and burning of coil	Repair or replace contactors
can not start	3. The power switch is not closed, malfunction or damaged	Close the switch and replace it if the power indicator does not turn on
	4. Thermal relay trip or damage	Check whether the motor is blocked, find out the reason and eliminate it.Manual reset is replaced if it cannot be started
	Water level is too low	Put water in the sink
	The motor burned	Repair or replace the motor
	1.Line is loose	Check wiring and tighten connectors
	2.Frequency converter malfunction	Check the fault content, check the cause according to the frequency converter manual, and restart after reset.Or disconnect the inverter power supply for a few seconds, the inverter fault reset before starting.
The manual is normal	3The frequency converter is damaged	Repair or replace
Automatic transmission failure	4.Pressure switch damage	Repair or replace
	5The pressure transmitter is damaged	Repair or replace
	6.Switch failure	Repair or replace
Pump non - suction pressure gauge pointer to beat violently	Insufficient water supply for perfusion, air leakage at the connection between pipeline and instrument	Check pipeline and bottom valve, refill water diversion. Tighten air leakage
The pump consumes too much power	Too much flow, impeller wear	Check whether the pump shaft is bent, replace the impeller, close the outlet valve to reduce the flow