High for Pressure Water Pump for Fire Engine

• Max.Head: 110m-150m
• Max.Capacity: 200-300 L/min
• Driving Type: Motor
• Impeller Number: Single-Stage Pump
• Working Pressure: High Pressure Pump
• Influent Type of Impeller: Single Suction Pump
• Model NO.: XBD-LV
• Position of Pump Shaft: Vertical Pump
• Pump Casing Combined: Verticaljoint Surface Pump
• Mounting Height: Since Irrigation Centrifugal Pumps
• Impeller: Closed
• Usage: Pump, Pumps
• Series: Xbd-LV
• Transport Package: Wood Box
• Specification: CE
• Trademark: Liansheng or OEM
• Origin: Shanghai, China
• HS Code: 84101330
• Production Capacity: 20000

Product Description

Product name: High pressure water pump for fire engine

Features: Whole sealing, no leakage, corrosion resistance.

Product introduction:
Fire pump as the name suggests, the fire pumps, fire pump is the introduction of foreign products, according to different classification, divided into different categories to its sealed, no leaks, corrosion-resistant characteristics, widely used in environmental protection, water treatment, fire and other departments for pumping all kinds of liquid, is created without leakage, no pollution culture workshop factory of civilization, the ideal pump and pump type fire system are the same, only the head and the flow are different.

Main applications:
Used for environmental protection, water treatment, fire and other departments for pumping all kinds of liquid, is the fire system creates no leakage, no pollution of civilization, civilization, the factory workshop.

Conditions of use:
XBD is applicable to transport temperature does not exceed 50 Centigrade water and is similar to the liquid water, water supply for fire water supply and other aspects.

The scope of performance parameter
XBD series a total of 170 specifications and its performance parameters range:

1. The rated flow from Q=5 to 80L/S
2. Pressure rating Mpa=0.35~2.8Mpa
3. Speed n=1480~2950r/min
4. Power P=3 ~ 315KW
5. Diameter of inlet DNA=50 ~ 200mm
6. Outlet diameter DNA=50 ~ 200mm

fault phenomenon	failure cause	elimination methods
	1.No power supply or one or two phase power supply is needed	Check all phases of power supply and restore power supply
	2.Poor contact of ac contactor and burning of coil	Repair or replace contactors
can not start	3. The power switch is not closed, malfunction or damaged	Close the switch and replace it if the power indicator does not turn on
	4. Thermal relay trip or damage	Check whether the motor is blocked, find out the reason and eliminate it.Manual reset is replaced if it cannot be started
	Water level is too low	Put water in the sink
	The motor burned	Repair or replace the motor
	1.Line is loose	Check wiring and tighten connectors
	2.Frequency converter malfunction	Check the fault content, check the cause according to the frequency converter manual, and restart after reset.Or disconnect the inverter power supply for a few seconds, the inverter fault reset before starting.
The manual is normal	3The frequency converter is damaged	Repair or replace
Automatic transmission failure	4.Pressure switch damage	Repair or replace
	5The pressure transmitter is damaged	Repair or replace
	6.Switch failure	Repair or replace
Pump non - suction pressure gauge pointer to beat violently	Insufficient water supply for perfusion, air leakage at the connection between pipeline and instrument	Check pipeline and bottom valve, refill water diversion. Tighten air leakage
The pump consumes too much power	Too much flow, impeller wear	Check whether the pump shaft is bent, replace the impeller, close the outlet valve to reduce the flow